JUMO 705040 mTRON T - Router Module Operating Manual - Manual (Page 11)

11
1 Introduction
Relay module 4-channel
Analog input module 4-channel
Analog input module 8-channel
• Four relay outputs controlled via the system bus by digital sig-
nals
• Each relay is equipped with a changeover contact
AC 230 V / 3 A
• Separate terminal strip per relay output
• Automatic configuration after the module insert has been ex-
changed during service work
• Dimensions (W x H x D): 22.5 mm x 103.6 mm x 101.5 mm
(without connection elements)
For further information: Refer to data sheet 705015
• Four universal analog inputs
• Supported measuring probes: Thermocouples, RTD tempera-
ture probes, resistance transmitters, resistance/potentiome-
ters or standard signals (current or voltage)
• The analog inputs are electrically isolated from each other
• Customer-specific linearization possible by using a formula or
up to 45 pairs of values
• Limit value monitoring
• Automatic configuration after the module insert has been ex-
changed during service work
• A digital input (DC 0/24 V) is also provided
• Dimensions (W x H x D): 22.5 mm x 103.6 mm x 101.5 mm
(without connection elements)
For further information: Refer to data sheet 705020
• Eight analog inputs for RTD temperature probes Pt100, Pt500
or Pt1000 in 2-wire circuit
• The analog inputs are not electrically isolated from each other
• Limit value monitoring
• Automatic configuration after the module insert has been ex-
changed during service work
• A digital input (DC 0/24 V) is also provided
• Dimensions (W x H x D): 22.5 mm x 103.6 mm x 101.5 mm
(without connection elements)
For further information: Refer to data sheet 705021