Brother HL-1260E - Manual (Page 46)

USER’S GUIDE
2–20
Pressing the POWER Switch
The POWER switch is on the front right hand side of the printer. Pressing
the ON side “ | ” supplies power to the printer, which then performs a self
test and warm up. Pressing the OFF side “O” turns the power off.
Fig. 2-23 Pressing the POWER Switch
!
Caution
Always wait at least 2 seconds after turning off the power before turning it
back on.
Do not turn the power off while the printer is printing, as this may cause a
paper jam and adversely affect the printer.
The printer performs a self-diagnosis at start-up to check its hardware and
software. If the printer should find any problems, the display will show the
corresponding message. See
“TROUBLESHOOTING” in Chapter 7 .
04 SELF TEST
The display shows several messages quickly at start-up. If the printer
detects no errors, it automatically goes on-line and the message changes to
show the current printer status and settings.
LJ READY 001P T1
LJ : The auto emulation selection is set and currently the HP
LaserJet 4+ emulation mode is selected.
READY : The printer is ready to print.
001 : The number of copies to print is set to 1.
P : Portrait print is selected.
T1 : Paper is fed from Tray1.
ON
OFF