Brother HL-1260E - Manual (Page 118)

CHAPTER 4 CONTROL PANEL
4–51
5. Press the SET switch.
When you enter the “SELECT FONT” menu, you can select the internal
font, optional slot font, or permanent download font. The display shows
the following message.
INTERNAL FONT p*
Press the ▲ or ▼ switch until the desired font source appears on the
display.
Display Message Font Source
INTERNAL FONT Internal font of the printer
SLOTFONT A Optional card font in the upper slot
A
SLOTFONT B Optional cartridge font in the lower
slot B
PERMANENT FONT Permanent download font defined
in the HP emulation mode
Since these steps instruct you to select the standard font, select the
“INTERNAL FONT” message.
✒ Notes
When you select the optional fonts or permanent download fonts, note the
following:
• If the optional font cartridge/card is not installed, the optional font
cannot be selected. No selection appears on the display.
•
If permanent fonts are not downloaded in the HP emulation mode or
another emulation mode is selected, they cannot be selected. No
selection appears on the display.
•
The list you can print out with the TEST switch helps you to select the
optional fonts or permanent download fonts. See
“TEST switch” in this
chapter or “Selecting the Optional Fonts” in Chapter 5 .
6. Press the SET switch.
When you enter the font setting mode, the display first shows the current
font with an asterisk.
BROUGHAM p*
7. Press the ▲ or ▼ switch until the desired font appears on the display.