Brother HL-1260E - Manual (Page 165)

CHAPTER 5 OPTIONS
5–9
4. Remove the left side cover by sliding it to the rear of the printer.
Fig. 5-6 Removing the Left Side Cover
✒ Note
Be careful not to connect the network interface cable into the modular jack
for options located inside the left side cover, or it may damage the printer.
5. Loosen the screws and then slide and remove the metal cover.
Fig. 5-7 Removing the Metal Cover
6. Unpack a SIMM and hold it on its edge.
✒ Note
Do not touch the memory chips or the board surface. If static electricity
collects, it damages the memory.
Screw(Yellow)