Brother HL-1260E - Manual (Page 153)

USER’S GUIDE
4–86
✒ Notes
The message “PRINT FONTS C” or “PRINT FONTS P” appears only
when the optional font cartridge/card is installed in the font slot or
permanent download fonts are stored in printer memory.
• If the optional font cartridge/card is installed, you can print out the list of
optional fonts. Since the list shows the ID numbers specific to each
optional font, it helps you to select them with the FONT switch. For
further information, see “FONT Switch” in Chapter 4 and “FONT
CARTRIDGE/CARD, FLASH MEMORY/HDD CARD” in Chapter 5.
•
If user-defined characters are already downloaded into the printer
memory as permanent download fonts, you can print out the list of them.
For further information, see “FONT Switch” in Chapter 4 and Technical
Reference Manual that is optionally available.
4. Press the SET switch to make the displayed selection effective.
The printer prints out the test patterns or lists according to the selected
test mode.
■ When the “DEMO PAGE” mode has been selected, the display shows
the following message and the printer starts printing out the
demonstration pattern.
06 DEMO PAGE
■ When the “TEST PRINT” mode has been selected, the display shows
the following message and the printer starts printing out the test pattern.
05 TEST PRINT
■ When the “PRINT CONFIG” mode has been selected, the display
shows the following message and the printer starts printing out the list of
printer settings.
06 PRINT CONFIG
✒ Note
The printed list shows the panel switch settings you have made as user
settings with the MODE switch. See “SAVE SETTINGS” in Chapter 4.