Brother HL-1260E - Manual (Page 152)

CHAPTER 4 CONTROL PANEL
4–85
TEST Switch
You can test the printer or print out the list of fonts with the TEST switch.
To do so, hold down the SHIFT switch and press the TEST switch. You will
then enter the test mode where you may test the printer or print out the list of
fonts.
To test the printer, follow these steps:
1. Press the SEL switch to set the printer off-line.
2. Hold down the SHIFT switch and press the TEST switch.
When you enter the test mode, the display shows the first test mode item.
DEMO PAGE
3. Press the ▲ or ▼ switch until the desired test mode appears on the
display.
Display Message Test Mode
DEMO PAGE Prints out the demonstration.
TEST PRINT Performs the printer test and prints
out the test pattern.
PRINT CONFIG Prints out the list of panel switch
settings you have configured for the
printer as user settings.
PRINT FONTS I Prints out the list of internal or
resident fonts.
PRINT FONTS C Prints out the list of optional fonts
stored in the font cartridge/card.
PRINT FONTS P Prints out the list of permanent
download fonts.
exit Exits from the test mode. The
printer does not perform the test.