INFICON Maxtek PM-700 Plating Monitor - Manual (Page 45)

PM-700 SERIES PLATING MONITOR
37
4.5.3.5 Setup Menu
Numonic Name/Description Minimum Maximum Default
Crystal
Type Crystal Type
Allows the user to set the
monitor to work with different
types of crystal frequency.
Selectable crystal frequency
are listed in the Minimum
column.
2.5 MHz
3 MHz
5 MHz
6 MHz
5 MHz
Electro
Area Crystal Electrode Area
Allows for Sensor Crystals
that have different electrode
area. Enter the electrode area
in cm
2
if the crystal in use is
not the monitor default area.
9.999 0.100 1.370
Thckness
Units Thickness Units
Allows the user to change the
monitor default thickness
measurement unit to a
different measurement unit.
Warning if selected thickness
measurement is not the default
unit, the Thickness Unit
Display will be off.
Selectable units are listed in
the Minimum column. For
other possible plating
measurement units, contact
manufacturer.
k
Χ
µ
Inch
Micron
µ
g/cm
2
mg/cm
2
Micron
Time
Units
Time Units
Similar to the Thickness Units
parameter, this parameter
allows the user the change the
manufacturer default setting.
The Rate Units Display will
be off when the default is
changed. Minimum column
listed three selectable Rate
Measurement Units. Call
Maxtek for other possible rate
measurement units.
Hrs
Min
Sec
Min