INFICON Maxtek PM-700 Plating Monitor - Manual (Page 43)

PM-700 SERIES PLATING MONITOR
35
Density Material Density
Allows setting of the density
of the material being plated so
that the monitor can calculate
and display the correct
physical film thickness. A list
of the commonly used
material density is presented
in Table 21.
0.800 99.90 1.000
Acoustic
Ratio Acoustic Ratio
Allows setting of the acoustic
impedance of the plated
material. This value is
necessary for the monitor to
accurately establish the sensor
scale factor when the sensor
crystal is heavily plated. A
list of the commonly used
material acoustic impedance is
presented in Table 21.
1.500 999.9 8.830
ElecChem ElectroChemical Equivalent
Allows setting of the electro
chemical equivalent of the
plated material. A list of the
commonly used electro
chemical equivalent value is
presented in Table 21. Note
this value is only needed for
the electrolytic plating bath.
Therefore, this parameter is
hidden if the Type parameter
is set to Elecless (electroless).
0.000 9.999 1.000