INFICON MDC-370 Thin Film Deposition Controller - Manual (Page 15)

MDC-370 DEPOSITION CONTROLLER
The MDC-370 also has a built in material library that contains many common
material names along with their density and acoustic impedance values.
1.3.7 INPUT/OUTPUT CAPABILITY
Sensor Inputs 2 Standard, up to 6 optional, BNC
inputs
Source Outputs 2 Standard, up to 6 optional, fully
isolated, 2.5, 5, 10 volts @ 20 ma.
0.002% resolution
Discrete Inputs 8 Standard, up to 16 optional fully
programmable inputs.
The Passive I/O card (PN#179216)
has TTL level inputs activated by a
short across the input pins.
The Active I/O card (PN#179239) has
inputs activated by 12 to 120 volt
AC/DC across the input pins.
Discrete Outputs 8 standard, up to 16 optional fully
programmable, SPST relay, 120VA,
2A max.
Abort Output 1 standard and 1 optional SPST
Relay, 120VA, 2A max.
Remote Power Handset Front panel, RJH jack
RS-232 Communication Rear panel, 9 pin, Full duplex, DTE
Front panel, RJ11 jack, Full duplex
DAC Recorder Outputs Two 0 to 5 volts, 0.02% resolution
1.3.8 SENSOR PARAMETERS
Number of Crystals 1 to 8
Shutter Relay Type Normally open, normally closed, dual,
or none.
Position Control Manual, direct, BCD, or individual.
Position Drive Up, down, Fast, inline, single step, or
double step.
Feedback Type Individual, BCD, single home, in
position, or no feedback.
Rotator Delay 0 to 99 sec
GENERAL DESCRIPTION 1-5