INFICON CrystalSix Sensor - Manual (Page 28)

2 - 14
IP
N 07
4-
15
5L
CrystalSix Operating Manual
Isolated 24 V(dc) source is available with a maximum of 0.4 amps total on
connector P4 at Pins 4, 9, 15 and 21 with Pins 8, 14, 20 and 25 used as returns.
2 In similar fashion, connect the Pneumatic Actuator for the source shutter if
required.
3 Connect the oscillator cable to the appropriate channel of the sensor board
programmed.
4 Connect the source one or source two cable (whichever has been
programmed) to the source controller.
Figure 2-7 Relay outputs: typical connector configuration utilizing relay #1
NOTE: Contact arrangements shown are of pin mating face (plug or receptacle).
The socket mating face is a mirror image of Figure 2-7 .
(P3)
(available on G2 only)
Bottom Relay Connector
Relay Pins
9 47, 50 9 13, 32
10 14, 17 10 14, 33
11 59, 63 11 15, 34
12 53, 60 12 16, 35
13 34, 36 13 12, 31
14 28, 30 14 11, 30
15 4, 11 15 10, 29
16 1, 5 16 9, 28
Table 2-1 Wiring Connectors (continued)