FasTest Bail Handle Gas Connectors - Manual (Page 10)

FasTest, Inc. 1646 Terrace Drive Roseville, MN 55113 Support: (800) 444-2373 Fax: (651) 645-7390 www.fastestinc.com 8
Bail Handle Compressed Gas Connectors
MaIntenance
Maintenance checklist
daily
Inspect for Leak-tight seal
• The main seal must be replaced more frequently depending on wear. Dismantling of the
connector for this purpose is not required. It is recommended that an O-ring pick be used for
removal to avoid damage to the groove
• Clean groove if required and insert new O-ring
Inspect for correct function.
• Does the safety pin properly protrude and lock the connector under pressure?
• Does the safety pin move backwards when the system is depressurized?
Weekly
Inspect for correct function
• Inspect the correct engagement of the collets
• Check the connector’s collet thread with gauge
• Check for any bent or missing components
periodic
• Inspect that all threaded components are tight and properly torqued
• Check for any bent or missing components
• Check for proper actuation of handle, collets and all moving components
• Check for leaks