FasTest XT Series Rebuild - Manual

REBUILD INSTRUCTIONS
Roseville, MN
Ph: 1-800-444-2373
Fax: 651-645-7390
www.fastestinc.com
WP070 10/6/2010
9. Place a small amount of petroleum jelly into the latching ball holes in the
body. This will help retain the balls while assembling the connector. Insert
the larger latching balls(3) into the latching ball holes in the body.
10. Lubricate the inside of sleeve(7) and slide it over the body(1) until it
bottoms. Make sure the small outside diameter of the sleeve is towards
the termination end.
11. Install the retaining ring(9) into the front groove in body.
12. Check connector operation and leak test.
13. Discard all used components.
FasTest, Inc. Product Warranty
FasTest, Inc. warrants its products against defects of workmanship and/or material for 12 months from the date of the
sale by FasTest, Inc. This warranty is void if the product is misused, tampered with or used in a manner that is not in
accordance with FasTest, Inc. recommendations and/or instructions. FasTest, Inc. is not liable for consequential or
other damages including, but not limited to, loss, damage, personal injury, or any other expense directly or indirectly
arising from the use of or inability to use its products either separately or in combination with other products. ALL
OTHER WARRANTIES EXPRESSED OR IMPLIED, WHETHER ORAL OR WRITTEN, INCLUDING BUT NOT
LIMITED TO WARRANTIES OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE
EXPRESSLY EXCLUDED.
Remedy under this warranty is limited to replacement of the product or an account credit in the amount of the original
selling price, at the option on FasTest, Inc. All allegedly defective products must be returned prepaid transportation to
FasTest, Inc. along with information describing the products performance, unless disposition in the field is authorized
in writing by FasTest, Inc.
XTR Rebuild Instructions
Description: XT Connector rebuild instructions
Please thoroughly read the instructions prior to
rebuilding the XT Connector. If you do not understand
instructions, or if components are missing, call FasTest
before rebuilding connector.
Disassembly:
1. Open the rebuild kit and remove instructions from bag. Slide the
sleeve(7) back toward the termination end to expose the retaining ring(9).
Using a pick (or like tool), remove the retaining ring. Note: the retaining
ring will be replaced.
2. Slide the sleeve(7) off the end of the connector opposite the termination
end.
3. The latching balls(3) can now be removed. They will either fall out or can
be pushed from the inside. Note: the balls will be replaced.
XT Connector Exploded View
LATCHING BALL HOLES
LATCHING BALL (3)