EUCHNER AS - Manual (Page 30)

Safety Monitors - AS-i Quick Reference - 08/2014 30
3. Select AS-I MASTER and press OK-button
4. Select AS-i CIRCUIT 1 and press OK-button
5. Read Software IDs
For analysing the fault, please write down „SWID“, „Safe CPU-A“, „Safe CPU-B“,
„UART 1“, „UART 2“.
3.12 States of GMOX Safety Monitor
Display
LCD AS-i-Slave-Addresses, Fault messages
LED power Power ON
LED PROFIBUS PROFIBUS-Master detected
LED config error Configuration wrong
LED U AS-i AS-i-Power OK
LED AS-i active AS-i-operation normal
LED prg enable Automatic slave addressing possible
LED prj mode Project mode active
LED AUX Auxiliary power connected
4 x LED EDM/Start State of inputs of external feedback loop monitoring
LED off: circuit open
LED on: circuit closed
4 x LED output circuits State of output circuits
LED off: circuit open
LED on: circuit closed
AS-I CIRCUIT 1
AS-I CIRCUIT 2
SAFETY SLAVE
INT MONITOR
EXT MONITOR
FAULT DETECTOR
DELTA LIST
LCS
ERROR COUNTERS
LPF
FLAGS
ACTUAL CONFIG
AS-I MASTER