EUCHNER AS User Manual
Page 20
Safety Monitors - AS-i Quick Reference - 08/2014
20
3.5 Replacing a defective slave (with teach-in of actuator)
If an AS-i safety slave is defective, it can be replaced even without a PC or reconfiguration of
the AS-i Safety Monitor by pressing the ESC/Service key on the AS-i Safety Monitor.
All safety slaves with necessity for teach-in of an actuator like CES and CET can be replaced
without using a PC with ASiMon according to this method.
Proceed as follows:
1. Disconnect defective slave from AS-i bus.
2. Connect new slave with address 0
The monitor addresses this slave automatically
3. Teach-in of actuator according to operation manual
4. Dissconnect new slave from AS-Interface Bus
5. Press the ESC/Service button on the AS-i Safety Monitor approx. 3 seconds.
6. Connect new slave AND bring into safe state
7. Press the ESC/Service button on the AS-i Safety Monitor approx. 3 seconds.
The code table for the new slave is taught and checked for correctness. If this is OK,
the AS-i Safety Monitor changes to protecting mode.
SLAVE 6 TO
BE CONNECTED
THEN PRESS
SERVICE LONG