Slave-address-tool in the safety monitor, 3 slave-address-tool in the safety monitor – EUCHNER AS User Manual

Page 18

Safety Monitors - AS-i Quick Reference - 08/2014

3.3 Slave-Address-Tool in the Safety Monitor

This function enables setting and changing the addresses of both new and already
configured AS-i slaves.

1. Press OK-button

2. Select SLAVE ADR TOOL and press OK-button

3. Select AS-I circuit in which is the Slave and press OK-button

4. Select CONNECT NEW SLV and press OK-button

5. Edit old and new address by OK-button
6. Select PRG and press OK-button

1 OFF 2 OFF

3 OFF 4 OFF

PROFIBUS
QUICK SETUP
AS-I SAFETY
DIAGNOSIS
SLAVE ADR TOOL
TEST
SETUP
DISP CONTRAST

SLAVE ADR TOOL
CONNECT NEW SLV
OLD ADDRESS
NEW ADDRESS

AS-I CIRCUIT

SLAVE ADR TOOL
OLD ADDRESS

NEW ADDRESS

PRG