Barco SLM R12+ - Manual (Page 147)

B. Built-In Dust Filters
B
A
Image B-11
Release dust filter at front side
2. Loosen the 4 captive screws (B) securing filter casing to projector front.
The dust filter is released and can be removed (C) for cleaning or replacement.
C
Image B-12
Removing dust filter from its casing
How to clean!
1. Put the dirty air filter far away from the projector or preferable in another room.
2. Brush most of the dust off with a soft brush and/or blow dust away with compresses air.
Tip: Always replace damaged and/or too dirty air filters by a new one.
How to reinstall the cleaned or new air filter
1. Slide the air filter (A) in its casing and hold it in place with one hand (B).
R5976654 SLM R12+ 27/01/2005 143