CHAMPION PP-28 Manual - Manual (Page 37)

29
Silencer
Whenever a booster heater is installed in the final rinse line, a water hammer arrestor shall be
installed after the valve and before the final water connection. The arrestor is factory precharged
at 22PSI and can handle a maximum shock pressure of 200PSI. A shrader valve is provided for
checking and recharging.We do not provide any repair parts for this component.
Water Line Strainer
A 1” line strainer is shipped with the PP-28. The line strainer is installed on the incoming water
supply line before the machine. The line strainer has a removable screen that should be cleaned
at least once a year depending on your water conditions, in some instances it may be as often as
every there months. There are no replaceable kits for the strainer. These are supplied as complete
units.
To clean the line strainer:
1. Turn the main water supply to the machine off.
2. Turn amchine on the off to bleed the pressure
off the line.
3. Remove the retaining nut from the line strainer
and extract the screen.
4. Flush the screen with water. If the screen is
damaged, replace the line strainer.
5. Reassemble in reverse order.
Figure 13
Line Strainer
COMPONENT REPLACEMENT