CHAMPION PP-28 Manual - Manual (Page 27)

19
ELECTRICAL SERVICE (CONT.)
Pump Timer
Refer to Fig.4 and Fig. 5
There are two timers in control cabinet of the PP-28,
one is located on the face of the cabinet panel and
controls the pump time, while the other one is
located inside the top of the control cabinet and
controls the final rinse time.
The Pump Timer controls the amount of time that the
pump will run during the wash cycle. This time is set
from the factory and pegged for the minimum time of
2 minutes. You are able to select the time settings from
2 minutes to 5 minutes depending on the amount of
soiled product. (See Fig. 4 for timer position).
The Final Rinse Timer controls the amount of time
for sufficient final rinse sanitizing. This timer is an
adjustable timer for 0 to 30 seconds. The factory
presets this timer for 16 seconds. (See Fig. 5 for
timer in cabinet).
The final rinse timer has the following user defined settings:
1. Adjustable timer range
2. Timer knob setting
3. Indicator light (ON when timer is counting)
4. 50 Hz or 60 Hz setting on the back/bottom of the timer
To Replace a Timer:
• Disconnect power to the machine at the main service switch.
• Remove the defective timer and install the replacement.
• Adjust the new timer setting to match the setting
of the original timer.
ELECTRICAL SERVICE
Figure 5
Final Rinse Timer
Figure 4
Wash Pump Timer
Image unavailable
at time of printing.