BAND-IT UL4000-B Cordless Ultra-Lok Tool - Manual (Page 5)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P07986 Rev. F
© Copyright
BAND-IT-IDEX, Inc. 2011
All rights reserved
www.BAND-IT-IDEX.com
Page 5 of 14
UL4000-B
UL4000-B220
Ultra-Lok

Tool
Settings
Important: Changing speed settings will alter tension output. Drill Switch should be depressed fully by
the operator to attain correct, and consistent, tension when installing clamps. Tension output may vary
from tool to tool, at the same setting, depending on condition and wear of internal components.
Caution: Improperly tightened clamps may result in dangerous assemblies, which could cause injuries
or property damage.
Using correctly sized clamps (diameter) will, in most cases, eliminate the need to pull on clamp tail more
than once. Tension Block moves approximately 5". On occasion, if needed, large size clamps can be
installed by taking several bites (clamp tail feeds out through back of tool). Position of Tension Block,
containing gripper, can be monitored through viewing holes just under cut-off handle. The tool features a
built-in disengaging mechanism to prevent tension screw from jamming up. Excessive use of this
feature will wear the Drill Clutch mechanism and/or Tension Screw out prematurely.
CAUTION!
This tool is designed to work mounted to the Bosch 37618-01 or Bosch GSR 18 VE-2LI cordless drill. Use
of any other drills in place of this Bosch drill may result in unsatisfactory performance, hazards to the
operator and/or the tool, or unsafe clamps. Disregard of this caution voids the warranty of the tool and
releases BAND-IT of any and all liabilities arising from such misuses.
Use of Alternate Drills
NOTE: These torque settings are suggested settings only; individual tools should be
adjusted for the clamping application. Inspect lock per instructions on page 9-11.
Recommended Drill Torque Dial Settings:
Drill Model
37618-01 / GSR 18 VE-2LI
Clamp Size ½" ¾"
Speed Clutch Speed Clutch
Single Wrap 1 22 1 24
Double Wrap 1 24 2 25
*Preformed 1 24 2 25
(If a higher pull-up force is desired, set speed selector to “2”. Band-It
recommends hearing protection if this setting is used for an extended time.)