BAND-IT UL4000-B Cordless Ultra-Lok Tool - Manual (Page 3)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P07986 Rev. F
© Copyright
BAND-IT-IDEX, Inc. 2011
All rights reserved
www.BAND-IT-IDEX.com
Page 3 of 14
UL4000-B
UL4000-B220
Ultra-Lok

Tool
Setup
Instructions
Use only with BAND-IT 3/4" and 1/2" Ultra-Lok Free-End and Preformed Clamps
Warning:
Always wear safety glasses when operating this tool and keep both hands and clothing away from clamp being
tensioned. Squeezing force of 3/4" clamp can reach as high as 2 tons. Never attempt to clamp objects which
can shatter, or otherwise cause bodily harm.
Speed Selector
Drill
Torque Dial
Tool Body
Adapter
M06287
Drill
M09599 (110V)
or M09699
(220V)
Tension Block Position Viewing Slot
(also lubrication syringe access)
Forward
Reverse
Switch
Adapter Collar
M08388
1. Read safety instructions and operator’s manual for the Bosch 37618-01 or Bosch GSR 18 VE-2LI cordless Drill.
Check to make sure drill is properly set up for use with Band-It Ultra-Lok  tool as follows:
---- Drill spindle has a Clutch (Band-It # M21790) installed in place of the Drill Chuck.
---- See page 5 for recommended Drill speed and torque settings.
2. Charge Drill Battery according to the operator’s manual.
3. To mount the Drill onto the Band-It Ultra-Lok
 Tool: First, using the two #10-32 x 3/8" screws, tighten the Tool Body
Adapter on the Tension Tool with 20–30 in-lbs. Place the Adapter Clamp over the Tool Body Adapter. Orient the Drill
Clutch Pin horizontally (see p. 4). Carefully place the Tool Body Adapter over the Drill Torque Dial. If there is any
additional resistance, gently rotate the Tension Tool until the Tension Screw engages with the Drill Clutch (see p. 4),
and rotate Tension Tool to the desired orientation. Position Tool Body Adapter to butt-up against the shoulder of the
handle mounting surface. Slide the Adapter Clamp against this shoulder and fasten to 40–60 in-lbs.
4. This tool was designed for, and can only be used with BAND-IT 1/2" and 3/4" wide Ultra-Lok
 clamps. Do not attempt
to use on any other type of clamp style. Only use 1/2" wide clamps when the optional 1/2" Shear Plate (BAND-IT
# M09387) has been installed in the head in place of the 3/4" Shear Plate.
Tool Head
Band Slot