Setup instructions – BAND-IT UL4000-C Cordless Ultra-Lok Tool User Manual

Page 3

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925

Document # P08986 Rev. A

BAND-IT-IDEX, Inc. 2012

www.BAND-IT-IDEX.com

Page 3 of 14

UL4000-C

UL4000-C220

Ultra-Lok Tool

Setup
Instructions

Read safety instructions and operator‟s manual for the Bosch DDH181-01 or Bosch GSR 18 VE-2LI Professional
cordless Drill. Check to make sure drill is properly set up for use with Band-It Ultra-Lok tool as follows:
---- Drill spindle has a Clutch (Band-It # M31790) installed in place of the Drill Chuck.
---- See page 5 for recommended Drill speed and torque settings.

2. Charge Drill Battery according to the operator‟s manual.

3. To mount the Drill onto the Band-It Ultra-Lok Tool: First, using the two #10-32 x 3/8" screws (M06187), tighten the

Tool Body Adapter (M06288) on the Tension Tool (UL0001) with 20

–30 in-lbs. Place the Adapter Collar (M08388)

over the Tool Body Adapter. Orient the Drill Clutch Pin (M07187) horizontally (see p. 4 Figure 2). Carefully place the
Tool Body Adapter over the Drill Torque Dial. If there is any additional resistance, gently rotate the Tension Tool until
the Tension Screw engages with the Drill Clutch (M31789) (see p. 4 Figure 3), and rotate Tension Tool to the desired
orientation. Position Tool Body Adapter to butt-up against the shoulder of the drill. Slide the Adapter Collar against
this shoulder and fasten to 40

–60 in-lbs.

4. This tool was designed for, and can only be used with BAND-IT 1/2" and 3/4" wide Ultra-Lok clamps. Do not attempt

to use on any other type of clamp style. Only use 1/2" wide clamps when the optional 1/2" Shear Plate (BAND-IT
# M09387) has been installed in the head in place of the 3/4" Shear Plate. See page 14 for ½” blade change
procedure.

Figure 1

Speed Selector

Drill

Torque Dial

Tool Body

Adapter

M06288

Drill
M19585 (110V)
or M19685
(220V)

Tension Block Position Viewing Slot

(also lubrication syringe access)

Forward
Reverse
Switch

Adapter Collar

M08388

Tool Head
Band Slot

Drill
Trigger