Warranty, Safety guidelines, Caution – BAND-IT UL4000-C Cordless Ultra-Lok Tool User Manual
Page 2: Use of alternate drills
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document # P08986 Rev. A
© Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
www.BAND-IT-IDEX.com
Page 2 of 14
UL4000-C
UL4000-C220
Ultra-Lok Tool
Warranty, Safety
Guidelines
Warranty
Refer to website for warranty information:
NOTE: Any performance data published herein is based on laboratory tests, which cannot duplicate conditions that may
be encountered in field installations. Such conditions may vary results substantially from those shown (such as abuse in
handling and installation, failure to follow recommended handling and installation practices, abnormal environmental
conditions, disregard of operating instructions for BAND-IT tools or non-recommended combinations of BAND-IT
products). BAND-IT cannot be responsible for performance characteristics from such variables.
Safety Guidelines
WARNING:
Always wear safety glasses when operating this tool and keep both hands and clothing away from clamp being
tensioned. Squeezing force can reach as high as 2 tons. Never attempt to clamp objects which can shatter or
otherwise cause bodily harm. Tensioning the clamp can be stopped immediately by releasing the trigger.
Detailed instructions are in this manual and the operator is advised to read it and become familiar with operating
the tool.
IMPORTANT FOR HOSE APPLICATIONS:
When clamping a hose end, remember that a tighter clamp keeps the fitting more secure, but excess
tension can damage the hose. Fitting stem must have prominent barbs for proper retention inside the
hose, but must not be sharp to prevent cutting into the hose. Hose, fitting, and clamp must be compatible
with each other and the environment used in. If in doubt, consult the hose or fitting manufacturer or call
BAND-IT.
Improperly tightened clamps may result in dangerous hose assemblies, which could cause injuries or property
damage.
Abuse or use of a hose outside the manufacturers recommended conditions may cause it to quickly deteriorate
and become a safety hazard. This could result in serious injury or property damage. Inspect and test hose
assemblies frequently.
Clamping objects other than hose requires similar precautions.
Use only with BAND-IT 3/4" and 1/2" Ultra-Lok Free-End and Preformed Clamps
CAUTION!
This tool is designed to work solely mounted to the Bosch DDH181-01 or Bosch GSR 18 VE-2LI
Professional cordless drill. Use of any other drills in place of these Bosch drills may result in unsatisfactory
performance, hazards to the operator and/or the tool, or unsafe clamps. Disregard of this caution voids the
warranty of the tool and releases BAND-IT of any and all liabilities arising from such misuses.
Use of Alternate Drills