BAND-IT UL4000 Cordless Ultra-Lok Tool - Manual (Page 3)

BAND-IT IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P07886 Rev. N
© Copyright
BAND-IT IDEX, Inc. 2013
All rights reserved
www.BAND-IT-IDEX.com
Page 3 of 14
UL4000
Ultra-Lok

Tool
Setup
Instructions
Use only with BAND- IT ¾” and ½” Ultra-Lok Free-End and Preformed Clamps
Warning:
Always wear safety glasses when operating this tool. Keep both hands away from clamp being tensioned. Use
common sense, squeezing force of ¾” clamp can reach as high as 2 tons. Never attempt to clamp objects which
can shatter, or otherwise cause bodily harm.
Gear Selector
Drill
Clutch
Tool Body
Adapter
M07687
Drill
M09485 ( DC987,
DC925, or equivalent)
or M07087 (DW987)
Tension Block Position
Viewing Slot
(also lubrication syringe access)
Forward
Reverse
Selector
Switch
Adapter Clamp
M08288
1. Read safety instructions and operator’s manual for the DeWalt DC987/DW987/DC925 cordless drill. Check to make
sure drill is properly set up for use with Band-It Ultra-Lok

tool as follows:
-----Drill spindle has adapter clutch (Band-It #M21790) installed in place of standard drill chuck.
-----Speed gear selector must be on number 1, and drill clutch torque setting as shown on page 5.
2. Charge drill according to the operator’s manual for the DeWalt cordless drill.
3. To mount drill onto Band-It Ultra-Lok tool: First use the two #10-
32 x 3/8” screws supplied with tool to tighten tool
adapter body to the tool. With adapter clamp on tool adapter body, insert drill into back of tool through the adapter
clamp. Turn drill manually to desired position in relation to tool. Press the drill firmly into tool. Actuate drill if necessary
to engage drill safety clutch (M21790) to tension screw. Tighten clamp screw while keeping the drill firmly pressed
against the tool. To remove drill from tool: loosen the clamp screw and pull drill away from the tool.
4. This tool was designed for, and can only be used with BAND-
IT ¾” and ½” wide Ultra-Lok 
clamps. Do not attempt to
use on any other type of clamp as it may damage tool. Only use ½” wide clamps when the optional ½” shear plate
(BAND-
IT #M09387) has been installed in the head in place of the ¾” shear plate.
Tool
Head
Band
Slot
Adapter
Clamp
Tension
Screw