It0750-ab, Troubleshooting matrix, 20 of 38 – BAND-IT IT0750-AB Mini Tie-Lok Tool User Manual
Page 20: Mini tie-lok tool
Document # I17775 Rev D
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
20 of 38
IT0750-AB
Mini Tie-Lok Tool
Symptom
Probable cause
Recommended Fix
Page
Control Module air pressure
valve is in "off" position.
Rotate Control Module valve to open position. Verify
gauges read air pressure and check all air
connections.
5
Clamp tail inside tool
Remove clamp tail, if jammed remove
maintenance/flip cover and remove clamp material.
15,17
Knife is in down position.
Remove or replace knife. Verify missing and or
damaged linkage.
23
Wrong clamp type for tool
Verify proper tool for selected clamp.
cover
Handle will not
adjust
Handle nut is
damaged/misaligned.
Remove handle assembly and inspect nut/housing for
damage. Replace as required.
9
Clamp will not
insert into tool
* = for additional assistance, contact BAND-IT
Troubleshooting
Matrix