BAND-IT IT0750-AB Mini Tie-Lok Tool - Manual (Page 15)

Document # I17775 Rev D
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
15 of 38
IT0750-AB
Mini Tie-Lok Tool
2.5”
1. Insert clamp tail into tool as shown. Clamp tail length
extending into tool must be at least 2.5” (6.4 cm) long. The
head of the tool should rest against the buckle. Note - Do
not activate tool while inserting clamp tail. This can
cause clamp tail to jam in the Tension Block Assembly.
2. Begin tensioning clamp by pushing and holding down
operating trigger
3. Band should be applied to a uniform solid surface allowing
the buckle adequate support during the clamp locking and
clamp tail cut-off operation.
4. While tensioning clamp, hold tool slightly tipped forward.
This will assist proper clamp installation. Continue to hold
down operating trigger until tool completely tensions and
cuts off clamp. Release trigger after cut off.
5. After clamp is completed, clamp tail scrap must be removed
from tool. Clamp tail scrap is not ejected automatically. Tool
is now ready for next clamp.
Operating
Instructions