AMMCO 700 Vehicle Brake Lathe - Manual (Page 22)

The switch on the motor will turn the driving unit ON and OFF,
and will also provide a switched outlet. When the drive unit
switch is in the ON position, the outlet will have power.
The lathe must be plugged into the outlet on the rotor driving
unit.
8. Before turning on the driving unit, double check to insure
the lathe is clear of the rotor, and that the lug adapter is securely
attached to the rotor hub.
9. The driving unit, as shipped from the factory, will provide a
counterclockwise rotation (when looking at the rotor). Check to
insure that rotation is into the face of the cutting bits.
10. Turn the drive unit on and proceed to recondition the
rotor, see RECONDITIONING DISC BRAKE ROTORS.
Brake Lathes
16 • AMMCO 700/705/710 Brake Lathes