AMMCO 927581 Mounting Hardware for the On the Car Lathe - Manual

Installation of the Storage Rack
Note: Use fig. 1 and the parts list to accomplish
steps 1 through 4. The numbers in parentheses rep-
resent the item number of the parts in the parts list.
1. Hang the storage rack (2) inside the lathe storage
chest.
2. Fully insert the screw (3), into the storage rack
(2), to secure the rack to the storage chest (1).
3. Place the mounting bolts (10) in the two circular
holes on the left end of the storage rack (2).
4. From left to right, the following parts should be
loaded on the storage rack (2) by pushing the parts
over the tongues on the rack: flat washers (9) and 1/8”
flat spacers (12), nut plates (11), 1/8” spacers (8), 1/4”
spacers (7), 1/2” spacers (6), 1” spacers (5), and 2”
spacers (4).
PART
ITEM NO. QTY DESCRIPTION
2 27579 1 Storage Rack
3 28220 1 Round Head Screw
4 27089-05 2 2” Spacers
5 27089-04 2 1” Spacers
6 27089-03 2 1/2” Spacers
7 27089-02 2 1/4” Spacers
8 27089-01 2 1/8” Spacers
9 27212 2 Flat Washers
10 27086-03 2 Mounting Bolts
11 27580 2 Nut Plates
12 29517 2 1/8” Spacers, Flat
13 27077 1 Wrench
Use of Mounting Hardware
1. The lathe mounting hardware was designed for
use on vehicles with a pressed hub/knuckle/rotor
assembly or where removal of the rotor is difficult or
inefficient.
2. The vehicle’s caliper bolts can be used to mount
the lathe if the holes in the steering knuckle or caliper
mounting bracket are threaded and on the inboard
side of the rotor, fig. 2. Also, the vehicle’s caliper bolts
should be 1-1/2” in length or longer. Otherwise, the
mounting bolts and nut plates provided in the hard-
ware package will be needed.
3. Whether you are mounting the lathe with the
vehicle caliper bolts or with the mounting bolts pro-
vided in the hardware kit, various combinations of
spacers may be required to take up the space
between the bolt heads and the lathe mounting
bracket to keep the bolt from interfacing with the
rotor.
Note: When using more than one spacer, care
should be taken to use the tongue and groove config-
uration to prevent misalignment, fig. 3. If the small
1/8” spacer is required, it should be placed on the
caliper bolt last since it does not have the counter-bore
the other spacers possess.
®
AMMCO Tools, Inc. • Hennessy Industries • P.O. Box 3002, 1601 J.P. Hennessy Drive, LaVergne, TN 37086-1982
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX
Mounting Hardware for the
On the Car Lathe
—Installation Instructions with Parts Identification—
No. 27581
Figure 1 Figure 2
Inboard Side
(toward
vehicle)
Outboard
Side (away
from vehicle)
Inboard Caliper
Mounting Bracket
Caliper Bolt (1-1/2”
Min. Length)