Brother HL-2600CN Series - Manual (Page 172)

CHAPTER 5 MAINTENANCE
5-60
Installing a HDD (Hard Disk Drive)
1. Turn off the printer and unplug the power cord from the AC outlet.
Disconnect the interface cable from the printer.
2. Unscrew the two screws
securing the rear plate of the
main controller board and pull
out the main controller board.
Fig. 5-79
3. Insert the 4 shoulder screws
supplied with the HD-6G/HD-
EX unit into the bottom of the
HD-6G/HD-EX.
Fig. 5-80
4. Connect the shorter Hard disk
cable to the HD-6G/HD-EX with
the keyed side upwards,
ensuring that it is correctly
aligned.
Fig. 5-81