5 routing – AirLive N450R User Manual
Page 79
AirLive N450R User’s Manual
74
1. Enable SNMP
You must check “Local”, “Remote” or both to enable SNMP function. If “Local” is
checked, this device will response request from LAN. If “Remote” is checked, this
device will response request from WAN.
2. Get Community
The community of GetRequest that this device will respond.
3. Set Community
The community of SetRequest that this device will accept.
4. IP 1, IP 2, IP 3, IP 4
Enter the IP addresses of your SNMP Management PCs. User has to configure to
where this device should send SNMP Trap message.
5. SNMP Version
Select proper SNMP Version that your SNMP Management software supports.
6. WAN Access IP Address
If you want to limit the remote SNMP access to specific computer, please enter the
PC’s IP address. The default value is 0.0.0.0, and it means that any internet
connected computer can get some information of the device with SNMP protocol.
Click on “Save” to store your settings or click “Undo” to give up the changes.
3.5.5 Routing
If you have more than one routers and subnets, you will need to enable routing table to
allow packets to find proper routing path and allow different subnets to communicate with
each other. The routing table allows you to determine which physical interface address to
use for outgoing IP data grams.