Appendix a: troubleshooting – AirLive N450R User Manual
Page 103
AirLive N450R User’s Manual
98
Q: Why can’t I configure the router even the cable is plugged and the LED is lit?
A:
Do a Ping test to make sure that the router is responding.
1. Go to Start > Run.
2. Type cmd.
3. Press OK.
4. Type ipconfig to get the IP of default gateway.
5. Type “ping 192.168.1.254”. Assure that you ping the correct IP Address assigned to
the router. It will show four replies if you ping correctly.
6. Ensure that your Ethernet Adapter is working, and that all network drivers are installed
properly. Network adapter names will vary depending on your specific adapter. The
installation steps listed below are applicable for all network adapters.
7. Go to Start > Right click on “My Computer” > Properties.
8. Select the Hardware Tab.
9. Click Device Manager.
10. Double-click on “Network Adapters”.
11. Right-click on Wireless Card bus Adapter or your specific network adapter.
12. Select Properties to ensure that all drivers are installed properly.
A
Appendix A:
Troubleshooting