Users – 2N StarGate/BlueTower v5.7 User Manual

Page 97

Users

This section helps you manage the SMS users. Select a communication protocol for
user adding (SMTP/POP3 or SMPP).

Add User

User group – assign the user to a User group.
User full name – define the system user name.
Replace dial for outgoing SMS – define the number (CPN) to which the user's
outgoing SMS messages shall be sent.
Access type – select the communication protocol for SMS processing:
Login name (without domain) – define the login name for the client Email.

Email (SMTP/POP3) – use SMTP for SMS sending and POP3 for SMS
receiving.
SMPP (SMSC) – set the GSM gateway into the 'SMS centre' mode.
SMPP (ESME) – set the GSM gateway into the 'ESME - External Short
Messaging Entity' mode.

System ID – SMSC user ID.
Password – SMSC/SMTP user password.
System ID (for authentication on remote side) – ESME user ID.
Password (for authentication on remote side) – ESME user ID.
TCP type – set the TCP parameter into the client/server mode.
Server address – set the server IP address and TCP server transport port.
Message direction of Esme – set the ESME user details:

Transceiver – ESME works as a transmitter/receiver.
Transmitter – ESME works as a transmitter.
Receiver – ESME works as a receiver.

Address range – set this parameter if required so by SMSC for SMS receiving
Delivery status required – set the SMS sending request for outgoing SMS
delivery confirmation.
Send message as Flash SMS – activate the Flash SMS function for outgoing
SMS messages.

Note

You can set the

parameter only if the

Delivery status required

SMTP/POP3 protocol is used.
With SMPP, the delivery information is active automatically in case the
service is required by the SMPP counterparty or via an incoming SMS
message from the GSM/UMTS network.
The user count is licence–limited. The highest possible count of licensed
users is 200. Refer to

for the current GSM

Management Licence key

gateway licence details.