2N StarGate/BlueTower v5.7 - Manual (Page 57)

57
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Main Installation
Place the gateway into an environment that complies with the gateway working
conditions.
Configure the gateway properly using the configuration software included.
The gateway mains supply must be backed-up and overvoltage-protected (a
line-interactive or on-line UPS is recommended).
Any of the available remote control tools (ISDN line, analogue line, Ethernet) are
advised for a more comfortable gateway administration.
Control Ways
The system can be supervised and controlled locally or remotely as follows:
Local control using a PC connected by a standard full crossed serial cable.
Remote connection over the IP network using the Telnet protocol or web
interface.
Remote connection over a data call to the ISDN PRI interface (not supported at
). present
Warning
Do not cover the top, bottom and rear sides of the gateway to avoid
overheating and gateway error!
Protection against humidity and extreme temperatures: The appliance
may never be placed close to heat sources (radiators) or places exposed
to direct sunshine. Also places with high humidity (such as bathrooms and
cellars), places with significant temperature fluctuation (next to doors,
windows), dusty places (workshops) and places exposed to aggressive
gases (accumulator rooms, boiler rooms) as well as places with intensive
vibrations and places exposed to shocks (compressor rooms, heavy
industrial operations) should be avoided. The system should be installed
horizontally.