2 configuration commands – 2N StarGate/BlueTower v5.7 User Manual

Page 149

149

2N TELEKOMUNIKACE a.s., www.2n.cz

4.2 Configuration Commands

Status Information

AT&V – Overview of all system settings
AT&VI –

Overview of ISDN PRI settings

AT&V0 –

Overview of basic GSM settings

AT&V# –

Overview of GSM group # settings (#=1-8)

AT&VALL –

Overview of all GSM group settings

AT&N# –

Overview of parameters of network list # (#=1-8)

AT&NALL –

Overview of parameters of all network lists

AT&R –

Overview of LCR lines

Default Reset

AT&FRES –

Reset with gateway factory settings

System Settings

AT%S70=x.x.x.x – IP address
AT%S71=x.x.x.x –

IP address mask

AT%S81= –

Initialisation string for setting of mode connected to the gateway

COM2
AT%S90=x –

Type of assignment of B-channels to GSM modules and X

0 – rotating
1 – locked
2 – according to credit

AT%S91=x,y –

Way of call information recording

0 – no record
1 – successfully connected outgoing call
2 – successfully connected incoming calls
3 – successfully connected incoming and outgoing calls
5 – all outgoing calls
6 – all incoming calls
7 – all incoming+outgoing calls

Y – to each call add NET info (1) or no (0)

AT%S93=x –

Global selection of SIM card and X:

0 – according to GSM group
1-8 – number of SIM holder

AT%S98=xxxx –

PIN code for SIM cards inserted in the gateway

AT%S99= dd.mm.yy.w/hh:mm:ss –

Gateway date and time settings

AT%X00=hout,hin,min –

Automatic logout of GSM modules

hout – hour when the modules start to log out randomly
hin – hour when the modules start to log in randomly
min – minimum number of modules in a group (2..15) that always remain
logged-in

AT%X80=name/pass –

Username/password for access via IP port (this

parameter is write only – you cannot see its value)