Gsm incoming groups – 2N StarGate/BlueTower v5.7 User Manual
Page 89
89
GSM Incoming Groups
2N StarGate / BlueTower
®
allows you to work with four groups of incoming calls.
You can set different values for each of them.
General Settings
– set how the gateway shall process incoming calls from the GSM network.
Mode
Reject incoming calls – all incoming calls from the GSM network are
rejected automatically.
Ignore incoming calls – all incoming calls from the GSM network are
ignored. The calling party hears the check ring tone.
Accept incoming calls
– incoming GSM calls are
+ voice message
accepted by the gateway and, if programmed so, DTMF with a voice
message is activated for them.
Accept incoming calls + dialtone – incoming GSM calls are accepted by
the gateway and, if programmed so, DTMF with a simulated second
dialtone is activated for them.
CallBack after ring / Reject – CallBack will be made if the CLIP is
included in the CallBack table. The other incoming calls will be rejected.
CallBack after ring / Ignore – CallBack will be made if the CLIP is
included in the CallBack table. The other incoming calls will be ignored.
Report to PC + voice message – the GSM gateway sends information on
the incoming call to a PC equipped with call routing application. If
programmed so, DTMF with a voice message is activated for the incoming
call.
Report to PC + dialtone – the GSM gateway sends information on the
incoming call to a PC equipped with call routing application. If programmed
so, DTMF with a simulated second dialtone is activated for the incoming
call.
Minimum digits in DTMF – set the minimum count of digits to be requested by
the gateway for DTMF.
Maximum digits in DTMF – set the maximum count of digits to be accepted by
the gateway for DTMF.
Timeout for entering DTMF digits [s] – set the timeout for which the GSM
gateway shall wait for the first/next DTMF digit. If you select ‘0’, the incoming
call will be automatically connected to the numbers included in the List of called
numbers.
Day of deleting GSM group statistics – set a day in a month on which the
incoming call statistics shall be deleted.
Prefix before DISA – set a numerical prefix to precede DTMF.
CLIP – use this parameter to modify the incoming CLIP from GSM/UMTS. For
international codes, ‘+’ will be removed automatically. Use ‘–’ to remove a digit.
Examples (CLIP in GSM: +420600123456):
Parameter
value
CLIP to VoIP/PRI
1
Note
Null
420261301500
No change in CLIP
+
+420261301500
Add + before CLIP beginning
00
00420261301500
Add 00 before CLIP beginning
––
0261301500
Remove two first digits from CLIP beginning
–––99
99261301500
Remove first three digits and add 99 before
CLIP