2N OfficeRoute - User manual, 1493 v1.9.0 - Manual (Page 16)

16
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2.4 PC Connection and LAN Connection
PC Connection
You need a direct interconnection of your 2N OfficeRoute/2N VoiceBlue
® ®
gateway and PC especially when you do not know the gateway IP address Enterprise
and thus cannot configure it using a web browser. In such a case, connect the gateway
directly to your PC USB port with the cable enclosed and select the basic network
parameters using your console interface. After the gateway is connected using the USB
cable, the PC detects new hardware. You have to choose the driver for 2N
®
, available on the CD in the package. OfficeRoute
You can control the console interface with any terminal-emulating program according
to the VT-100 specification at least such as HyperTerminal or PuTTY.
Note
The HyperTerminal is not installed by default in the newest
Microsoft Windows OS. For serial connection to the gateway use
an alternative program such as PuTTY.
By default, the gateway serial port communication parameters are set at 921,600 bits
, , , , . Set the per second 8 data bits no parity 1 stop bit no flow control
communication program on the PC side identically. If you are using PuTTY for serial
communication, you can use settings as shown in Fig. 2.6. It is necessary to choose
the
connection type and the COM number on which the gateway is connected Serial
for the serial line type. The rate is 921600. Click on the button. Open
Figure 2.6: PuTTY – Serial Console Access Configuration