2N OfficeRoute - User manual, 1493 v1.9.0 - Manual (Page 14)

14
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2.3 Mounting
Proper Mounting
The device is designed for mounting on a vertical surface. For this purpose, a
wall– mounting holder is available. Just fit the holder to the wall using dowels
and screws and hang the device.
Figure 2.3: Gateway Holder – Wall Mounting
Figure 2.4: Gateway Holder – Hanging
It is possible to operate this device in another working position (e.g. on a desk)
but it may deteriorate the GSM signal if the antenna is situated horizontally.
Do not exceed the allowed working temperature and relative humidity ranges.
Exceeding the recommended operating temperature values need not affect the
gateway function immediately but may result in a more rapid ageing and lower
reliability.
The device is intended for indoor use only. It may not be exposed to rain, flowing
water, condensed moisture, fog, or mist.
The device may not be exposed to aggressive gas, acid vapours, solvents, etc. or
aggressive liquids, during cover cleaning, for example.
The device is not designed for high-vibration environments, e.g. means of
transport, machine rooms, etc.
Free space has to be left under and over the device for cables and agitated air to
remove operational heat.
Install the device on a place with a good UMTS/GSM signal.