2N Lift emergency phone 2N SingleTalk - Manual, 1514 v6.3.0 - Manual (Page 48)

2N® SingleTalk Programming
3.1
47
Tip
 To check programmed values: enter parameter number and , listen
the parameter value and press for return to the main menu.
Caution
 Unfortunately, some telephone sets become “mute” for a second after
sending the DTMF signal. Try to use another telephone in this case.
Programming Error
 If you make an error while entering a number (whether a wrong function
number or value) and you recognise it before entering an asterisk, push to
cancel the number and enter a new one.
 If the ST rejects the selected parameter number or value, the programming
procedure can continue – the function number must be re-entered even if only
the value was wrong.
 If you program a false value and it gets stored, you can re-enter the value of
course.
Programming Termination
 Having stored all values you needed to change, terminate programming by
pressing . The ST sends a hang-up signal and hangs up.
 If you do not use , the ST hangs up later without influencing your storage
(the values are stored immediately upon entering).
 In doubts, make sure that the programmed ST behaves according to your
assumptions.
 Keep the filled-in programming form on a safe place.