Table of parameters 3.2 – 2N Analogue GSM gateway 2N EasyGate PRO - Manual, 1749 v1.03 User Manual
Page 36

Table of Parameters
3.2
36
Number length
Function No.: 393
The parameter defines the expected length of a number with a prefix included on
the same line. This enables to start dialing into a mobile network immediately
after the last digit is dialed. If the telephone number to be dialed is shorter, a
timeout is respected. The "0" setting means that the function is disabled.
Setting options:
0, 3-15
Setting step:
1
Default setting:
0
End with #
Function No.: 394
This parameter enables to establish the call when a # is received. The # character
is removed from the dialed number. If a # should be part of the dialed number,
this function cannot be used for the given prefix.
Setting options:
YES (1)/NO (0)
Default setting:
NO
Remove
Function No.: 395
The Remove parameter is used for automatic call routing. A defined count of digits
(prefix) is removed from the number beginning.
Setting options:
0-20
Setting step:
1
Default setting:
0
Add
Function No.: 396
The Add parameter is used for automatic call routing. A defined string (prefix) is
added to the beginning of the number to be dialed.
Setting options:
0-8 characters (0-9,*,#,+)
Default setting:
blank
Extra tariff
Function No.: 397
Pseudo tariff metering setting (tariff is based on call duration). The Extra tariff
parameter defines transmitting of fixed quantity of tariff pulses after call start.
This parameter sets minimal call cost.
Setting options:
0-255
Setting step:
1
Default setting:
0
Tariff [s]
Function No.: 398
Pseudo tariff metering setting (tariff is based on call duration). The Tariff
parameter sets the call cost according to call duration. Set how often in seconds
do you want to transmit pulses. Smaller number means more expansive call. Zero
means not to transmit pulses according to call duration.
Setting options:
0-255 s