2 table of parameters, Telephone interface fxs parameters, Table of parameters 3.2 – 2N Analogue GSM gateway 2N EasyGate PRO - Manual, 1749 v1.03 User Manual
Page 29: Dialing parameters

Table of Parameters
3.2
29
3.2 Table of Parameters
All programmable parameters are listed in this section. Each parameter is
accompanied with the unit used, function number (if available) for programming via a
telephone line, description of EasyGate's behavior, setting options, setting step and
default (initialization) value.
Numeric parameters must be set in unit listed in the parameter description. For
parameters with different setting are values defined in the parameters description (for
phone line programming in parenthesis). When phone line programming is used,
character
can’t be included in the string, because it is dedicated for confirmation
of the new parameter value.
Telephone interface FXS parameters
Dialing parameters
Type of dialing
Function No.: 100
Select the dialing type to be received by EasyGate on the FXS interface. 2N®
EasyGate accepts only the selected type of dialing, ignoring the others.
Setting options:
DTMF (0) -EasyGate receives tone dialing only.
Pulse (1) -EasyGate receives pulse dialing only
Default setting:
DTMF
Time to dial [s]
Function No.: 101
Timeout during which EasyGate waits for further digits to be dialed. It starts to
establish connection when this timeout passes.
Setting options:
1-255 s
Setting step:
1 s
Default setting:
5 s
Minimal On Hook [ms]
Function No.: 102
The minimum line current break that EasyGate evaluates as hang-up.
Setting options:
100-25500 ms
Setting step:
100 ms
Default setting:
500 ms
DTMF during call
Function No.: 107
When DTMF is transmitted in voice channel of GSM or UMTS network problem with
quality can occur, because the compression used for voice transmit can damage
the signal. You can set digital transmission mode, than SmartGate mutes original
DTMF signal from telephone line, and instead of this transmits digital DTMF in