Table of parameters 3.2 – 2N Analogue GSM gateway 2N EasyGate PRO - Manual, 1749 v1.03 User Manual
Page 35

Table of Parameters
3.2
35
An example in the figure below shows how to bar all international calls with the
exception of calls to Slovakia including dialing acceleration by selecting the number
length parameter and tariff setting (5 impulses after call connect and then one
impulse every 10 seconds). All other calls are enabled and their tariff is one impulse
every 30 second.
Operator for Integra
Function No.: 405
In some networks you can add to dialed number # character and PBX subscriber
number. Subscriber number is displayed on other side together with CLI. This
parameter take place when dialed number doesn't contain # character.
Setting options: 0-8 characters (0-9)
Default setting: blank
Caution!
n
Configuration using phone line programming (DTMF) is applicable for line
‘Other prefixes’ only.
Prefix
Function No.: -
A prefix identifying the call type (mobile, trunk call, free call, etc.). The letter ‘?’
can be used instead of any number. "Other numbers" line is used for calls with
prefixes that are not included in the table.
Setting options:
0-14 characters (0-9,*,#)
Default setting:
blank
Call enable
Function No.: 391
This parameter allows/bars calls with prefixes included on the same line.
Setting options:
YES/NO
Default setting:
YES
Figure 3.2
Routing table