JLG 4017 Service Manual - Manual (Page 149)

9.29 4017
Electrical System
d. Switch Installation
1. Connect the switch to the cab harness connector.
2. Position the switch over the rectangular switch bezel
and snap into position.
3. Connect the negative (-) battery cable to the negative
(-) battery terminal.
4. Start the machine and check the replaced switch for
proper function.
5. Close and secure engine cover.
1. Head Light Switch
2. Work Light Switches
3. Rear Wiper/Washer Switch
4. Machine Sway Switch
5. Rotating Beacon Switch (optional)
6. High Beam Indicator
7. Battery Charge Indicator
8. Turn Signal Indicator
9. Trailer Turn Signal Indicator (optional)
9.15 Transmission Control Lever / Accessory
Control Lever
9.15.1 Control Lever Replacement
The transmission control lever (10) is on the left side of
the steering column. The accessory control lever (11) is
on the right side of the steering column.
a. Lever Removal
1. Open engine cover. Allow engine to cool.
2. Disconnect the negative (-) battery cable at the
negative (-) battery terminal.
3. Loosen and remove the two allenhead screws (12).
4. Disconnect the wiring harness connector from the
lever base and remove.
b. Disassembly
DO NOT disassemble the control lever. Replace a
defective lever with a new lever.
c. Inspection and Replacement
Inspect the switch terminals for continuity. Replace a
defective or faulty lever with a new lever.
d. Lever Installation
1. Connect the wire harness connector to the lever
base.
2. Install both allenhead screws into the accessory
control lever base and tighten the two screws into
the transmission control lever base.
3. Connect the negative (-) battery cable at the negative
(-) battery terminal.
4. Start the machine and check the functions of the
replaced lever.
5. Close and secure engine cover.
1
2
3
4
5
7 6
9
8
MZ1461
11
10
12