JLG 601S ANSI Service Manual - Manual (Page 19)

SECTION 1 - SPECIFICATIONS
3120746 – JLG Lift – 1-3
Test Notes
1. Stop watch should be started with the function, not
with the controller or switch.
2. All speed tests are run from the platform. These
speeds do not reflect the ground control operation.
3. The platform speed knob control must be at full
speed (turned clockwise completely).
4. Function speeds may vary due to cold, thick hydrau-
lic oil. Test should be run with the oil temperature
above 100° F (38° C).
5. Some flow control functions may not work with the
speed knob clicked into the creep position.
1.5 TORQUE REQUIREMENTS
Table 1-1. Function Speeds (In Seconds)
Function Time
Lift Up 46-60
Lift Down 33-43
Swing Right & Left* 79-101
Telescope Out 50-67
Telescope In 35-40
Platform Rotate Right & Left** 16-25
Drive Forward & Reverse (4WD) 37-45
Drive Above Horizontal - Forward & Reverse (2WD &
4WD) 43-136
*Max 10% Difference Between Left & Right
**Max 15% Difference Between Left & Right
4150130 - E
Table 1-2. Torque Requirements
Description
Torque Value
(Dry)
Interval Hours
Bearing To
Chassis 240 ft. lbs.
(326 Nm)
See Note
50/600*
Bearing To
Turntable 240 ft. lbs.
(326 Nm)
See Note
50/600*
Wire Rope 15 FT. LBS
(20 Nm)
150
Wheel Lugs 170 FT. LBS.
(231 Nm)
150
*Check swing bearing bolts for security after first 50
hours of operation and every 600 hours thereafter.
(See Swing Bearing in Section 2.)
NOTE: When maintenance becomes necessary or
a fastener has loosened, refer to the
Torque Chart to determine proper torque
value.