JLG 601S ANSI Service Manual User Manual
Service and maintenance manual, Model 601s
Table of contents
Document Outline
- Section A. INTRODUCTION - MAINTENANCE SAFETY PRECAUTIONS
- Section 1. specifications
- Section 2. General
- Section 3. Chassis & Turntable
- 3.1 Torque Hub, Drive
- 3.2 Torque Hub, Drive (Auburn Gear)
- 3.3 Drive Brake - Ausco
- 3.4 Drive Brake - Mico
- 3.5 Drive Motor (Prior to S/N 85132)
- 3.6 Drive Motor Adjustment Procedure (PRior to S/N 85132)
- 3.7 Drive Motor (S/N 85132 to Present)
- 3.8 Free Wheeling Option
- 3.9 Oscillating Axle Bleeding Procedure and Lockout Test
- 3.10 Steer Adjustments
- 3.11 Swing Hub
- 3.12 Swing Bearing
- 3.13 Swing Brake - Ausco
- 3.14 Swing Motor
- 3.15 Tilt Alarm Switch (Machines with External Tilt Sensor)
- 3.16 Spark Arrester Cleaning Instructions
- 3.17 Dual Fuel System
- 3.18 Electric Governor Installation and Adjustments - Ford Engine
- 3.19 Throttle Checks and Adjustments - Deutz Engine (Prior to S/N 61306)
- 3.20 Automatic Choke Adjustment - Ford Engine
- 3.21 Cold Weather Starting Difficulty
- 3.22 Checking the Fuel
- 3.23 Ford EFI Engine (machines after S/N 58209)
- Section 4. Boom & Platform
- Section 5. Hydraulics
- 5.1 Cylinders - Theory of Operation
- 5.2 Valves - Theory of Operation
- 5.3 Cylinder Checking Procedure
- 5.4 Cylinder Repair
- 5.5 Cylinder Removal and Installation
- 5.6 Variable Displacement pump (M46 series)
- 5.7 Pressure Setting Procedures
- 5.8 Directional Control Valve
- 5.9 Hydraulic Pump W/Hayes Pump Drive Coupling Lubrication
- 5.10 Hydraulic Component Start-Up Procedures and Recommendations
- Section 6. JLG CONTROL SYSTEM (ADE)
- 6.1 Introduction
- 6.2 To Connect the JLG Control System Analyzer
- 6.3 Using the Analyzer
- 6.4 Changing the Access Level of the Hand Held Analyzer
- 6.5 Adjusting Parameters Using the Hand Held Analyzer
- 6.6 Machine Setup
- 6.7 Level Vehicle Description
- 6.8 Machine Personality Settings
- 6.9 Analyzer Diagnostics Menu Structure
- Section 7. schematics