JLG Workstation in the Sky-Boom Lifts - Manual (Page 122)

SECTION 6 - SKYAIR™
6-2 – JLG Accessory Manual – 3124242
DESCRIPTION
This belt-driven air compressor supplies compressed air to the platform. A
filter/regulator controls air pressure (located at the platform). An on/off
switch controls power to the air compressor (located in the engine compart-
ment).
Compressor Specs
Single Stage with Dual Control
CFM Displacement: 9.3
Motor: 230-volt, 2 horsepower, 3 phase
ACCESSORY RATINGS
SAFETY PRECAUTIONS
General
READ AND UNDERSTAND THE OPERATORS MANUAL FOR THE SPECIFIC JLG MODEL
BEING USED.
DO NOT OVER LOAD PLATFORM.
1. Make sure no personnel are beneath platform.
2. This factory installed option is available only on models specified.
3. Keep lanyard attached at all times.
PREPARATION AND INSPECTION
Ensure compressor & hoses are secure, check condition of belt and wiring.
OPERATION
Start engine. Turn on generator. Turn on compressor. Begin using.
SERVICE AND MAINTENANCE
Refer to J-Air Service and Maintenance Manual.
CONTROL MODE VOLUME
Automatic Start-Stop Control
Constant Run Control 100-130 PSI
105-120 PSI