JLG 4013PS Service Manual - Manual (Page 233)

9-93 3508PS, 3509PS, 3512PS, 3513PS, 4008PS, 4009PS, 4012PS, 4013PS, 4017PS, 40.8, 40.9
Electrical System
GROUND MODULE
VLOW FET FAILURE 9986 1 Suspend all hydraulic function and
engine operation, and command
the transmission to neutral.
The UGM has detected an anomaly
in a mosfet.
Power cycle.
(Replace
board)
FUNCTIONS
LOCKED OUT – LSI
SOFTWARE
VERSION
IMPROPER 99151 1 If active, the control system will
respond as if the Load Moment
Cutout % parameter has been
reached and react accordingly
depending on the MARKET
configuration.
Set CAN message bit to permit LSI
System display control of its alarm.
The UGM has detected the LSI
module software revision # is not
compatible [(Major version 0, minor
11) OR (Major version 1).
Power cycle.
(Install proper
LSI)
LSI FAULTY –
SYSTEM FLASH
CRC ERROR 99152 1 If active, the control system will
respond as if the Load Moment
Cutout % parameter has been
reached and react accordingly
depending on the MARKET
configuration.
Set CAN message bit to permit LSI
System display control of its alarm.
The LSI System has detected a
checksum error with its system
flash and is reporting the issue on a
CAN bus message to UGM.
Power cycle.
(Replace LSI)
LSI FAULTY – DATA
FLASH CRC ERROR 99153 1 If active, the control system will
respond as if the Load Moment
Cutout % parameter has been
reached and react accordingly
depending on the MARKET
configuration.
Set CAN message bit to permit LSI
System display control of its alarm.
The LSI System has detected a
checksum error with its data flash
and is reporting the issue on a CAN
bus message to UGM.
Power cycle.
(Replace LSI)
LSI FAULTY – LOAD
CELLS A AND B
DISAGREEMENT 99154 1 If active, the control system will
respond as if the Load Moment
Cutout % parameter has been
reached and react accordingly
depending on the MARKET
configuration.
Set CAN message bit to permit LSI
System display control of its alarm.
The LSI System has detected a
unacceptable variance in the
readings between Load Cell A and
Load Cell B and is reporting the
issue on a CAN bus message to
UGM.
Power cycle.
(Recalibrate
or replace LSI
sensor)
Message Fault
Code
Indicators Other Actions Taken Trigger for Fault Latch Until