JLG 4013PS Service Manual - Manual (Page 148)

Electrical System
9-8 3508PS, 3509PS, 3512PS, 3513PS, 4008PS, 4009PS, 4012PS, 4013PS, 4017PS, 40.8, 40.9
9.5.6 Cabin Joystick Telescope: X-Axis/
Roller
To change the joystick telescope function on the joystick:
1. Turn the engine to the ON position.
2. Press the "C" and "OK" buttons on the dash
simultaneously to enter the analyzer mode.
3. Scroll to "Access level code". Enter the code
"33271" to go into access level 2.
4. Scroll to and select the "Operator Tools" screen.
5. Scroll to and select the "Cabin Joystick Telescope"
screen.
6. Select either X-AXIS or ROLLER.
Note: When changing the joystick function, ensure the
correct joystick operation decal is installed. Contact your
local authorized distributor.
9.6 FUSES AND RELAYS
9.6.1 Cab
For access to the fuse and relay panel, remove the
screw (1) securing the right side console access
panel (2) to the cab. The fuses and sealed 12-volt relays
are mounted under the right side console access panel.
The fuse and relay panels are part of the cab harness.
9.6.2 Engine Compartment
The fuse and relay bar is located on the frame directly
above the engine. The fuse and relay bar contains the
glow plug fuse (3), glow plug relay (4) and starter
relay (5). To remove the relays from inside the engine
compartment, remove the mounting screws and washers.
MZ1990
2
1
MZ2100
3
4
5