Eppendorf TransferMan4 r - Manual (Page 80)

80
Troubleshooting
TransferMan
® 4r
English (EN)
7.1.4 Joystick
7.1.5 Software and parameters
7.2 Error messages
7.2.1 Warnings
The display does not
show anything or the
device cannot be
activated although the
device is connected. • The power cable or power
plug is loose.
• The device is switched off.

Check the power cable or
the power plug.

Switch the device on.
Symptom/message Cause Remedy
Outer movement range
of the joystick does not
work. • Outer movement range is
deactivated.

In the Installation menu, set
the value for Dyn-mode to
ON .
Symptom/message Cause Remedy
Parameters are not
accessible for certain
operations. –

Enter parameters again.

Carry out a reset and reset
all parameters to the works
settings.

Readjust device.
Symptom/message Cause Remedy
WARNING 1 • FemtoJet is not connected.

Disconnect the data cable to
the FemtoJet and connect it
again.

Switch on the FemtoJet.
WARNING 3 • X-module is not connected.

Switch off the device.

Connect the plug of the
X-module to the control
board and tighten.

Switch the device on.
WARNING 4 • Y-module is not connected.

Switch off the device.

Connect the plug of the
Y-module to the control
board and tighten.

Switch the device on.
Symptom/message Cause Remedy