Advance Adapters AX15 - Manual (Page 40)

40
GM BELLHOUSINGS
CLUTCH LINKAGE & TRANSFER CASE BRACKETS:
P/N 712577 - Chevy NV4500 A.A. bellhousing (1993 to 95 transmissions) conversion bellhousing
P/N 712576 - Chevy NV4500 A.A. bellhousing (1996 & up transmissions) conversion bellhousing
P/N 712580 - Chevy NV4500 GM bellhousing (1993 to 95 transmissions) stock bellhousing
P/N 712586 - Chevy NV4500 GM bellhousing (1996 & up transmissions) stock bellhousing (internal slave cylinder)
The recommended clutch components for the bellhousings listed above are found in the
GM Full Conversion Bellhousing section of this manual.
P/N 715534 - Stock linkage bracket (mechanical)
P/N 715535 - Stock linkage bracket (hydraulic)
P/N 716332 - Bellhousing boot for (P/N 712576 & 712577)
P/N 715529 - NV4500 to NP205 T/C shifter bracket
(1971-85) GM 2WD NV4500:
We also offer a list of parts required for the GM 2WD trucks. These parts are designed to be used with a DODGE 2WD NV4500 .
We do not carry this model transmission, but a it can be special ordered though us. The 1998 and newer transmissions do not
offer any type of speedometer provisions. When obtaining your transmission, we recommend that a 1997 & earlier transmission
be obtained.
NOTE: The handle assembly in this kit fits the 1998 & earlier transmission handle configuration. If you have decided
to use a later model transmission without a speedometer drive, then you will need to substitute P/N 716050D with P/N
716050D1 .
DODGE 2WD NV4500 to GM 2WD 1971-85 transmission retrofit
The bellhousing adapter plate in this kit retains the stock bellhousing. This kit requires the use of a stock GM bellhousing
with a 5.125” index diameter. The stock clutch disc must be a 1-1/8” 10 spline to fit the NV4500 transmission. The necessary
clutch components for this conversion can be found in the GM Adapter Plate section of this manual. We have included a new rubber
crossmember support to fit the stock tailhousing. The stock crossmember will require some modifications to bolt to our rubber
crossmember support.
P/N 712550 - Adapter plate kit
P/N 716101-2 - Rubber mount for crossmember
P/N 716050D - Shifter handle assembly