Advance Adapters AX15 - Manual (Page 15)

r
p
p
716050D1
p
Roll Pin
716050D
Stock Dodge 1993-98 shift tower
Stock Dodge 1999-2002 shift tower
P/N 716050D1
(Dodge 1999 & Newer)
SHIFTER KIT CONSISTS OF:
P/N 716050 - Shifter handle base
P/N 716050H - Shift handle
P/N 716050K - Shift knob
P/N 720061 - 10mm X 1.5 50mm stud bolt
P/N 726203 - 5/8"-18 Hex jam nut
P/N 716050D
(Dodge 1993-98)
SHIFTER KIT CONSISTS OF:
P/N 716050H - Shifter handle
P/N 716050K - Shift knob
P/N 716050S - Shift handle stud
P/N 720061 - 10mm X 1.5 50mm long stud bolt
P/N 726203 - 5/8"-18 Hex jam nut
SPECIAL NOTES:
1. Remove rubber boot.
2. Remove retaining cup - Push down and turn cup counter clockwise, then pull straight stud out of top cover.
3. Remove old stud by driving 1/4" roll pin out of base.
4. Slide the stock spring over the shifter stud (large end up).
5. Install Part No. 716050S into base. Reassemble using original 1/4" roll pin.
P/N 716050C
(Chevy 1993 & UP)
SHIFTER KIT CONSISTS OF:
P/N 716050B - Shifter handle base
P/N 716050H - Shift handle
P/N 716050K - Shift knob
P/N 720061 - 10mm X 1.5 50mm long stud bolt
P/N 726203 - 5/8"-18 Hex jam nut
Stock GM 1993 & Up shift tower
716050C
Stock Dodge 2003 & Newer
shift tower
SHIFTERS
The year and the model of your NV4500 transmission (GM or Dodge)
will determine the shift handle assembly you will use. Both GM and
Dodge offer shift handle assemblies; however, the cost of these
stock handles are not favorable. The shift handles we offer are
easy to install and, if necessary, easy to modify to fit your vehicle.
We offer 3 shifter configurations to fit the different models manu-
factured.
15
Note; Since there are numerous
transmission rebuilder working on
the NV4500. The top covers are eas-
ily switched out for one another. The
shifter on this page are for the stock
top cover on non rebuilt transmis-
sion. If you are buying your trans-
mission from a rebuilder, you
should verify the handle configura-
tion so as to receive the correct
handle.