Toyota land cruiser transfer case adapters for – Advance Adapters AX15 User Manual

Page 29

TOYOTA LAND CRUISER TRANSFER CASE ADAPTERS FOR

1993-2000 DODGE 23 Spline 4WD NV4500s:

These kits are designed to fit the

Dodge 4WD NV4500

transmission. The stock output shaft must be shortened so that when

our spud shaft is assembled it does not push the stock output shaft towards the transmission causing a pre-load on the
transmission bearings. The stock tailhousing is replaced with our new adapter which measures 6.375” long. When bolting this
transmission to one of our GM conversion bellhousings, the overall assembly length on all three installations will be

25.375”

. The

transfer case shift controls will need to be modified to be used with this transmission. There are two 3/8” holes located on the
side of the adapter for the mechanical shifter linkage. If your vehicle has a 3 speed vacuum-type shifter, these holes are not going
to be used. They will need to be plugged with the hardware provided in the kit along with a small amount of silicone.

P/N 50-0225

Dodge 4WD NV4500 replacing FJ40 3 speed (10 spline)

P/N 50-0226

Dodge 4WD NV4500 replacing FJ40 4 speed (16 spline)

P/N 50-0227

- Dodge 4WD NV4500 replacing FJ40/FJ60 4 speed (19 spline split-case)

This adapter does not have provisions to retain the stock transmission crossmember. When using this NV4500 adapter, a custom crossmember

will need to be fabricated.

TOYOTA LAND CRUISER TRANSFER CASE ADAPTERS FOR

1993-2003 DODGE 29 Spline 4WD NV4500s

These kits fit the

Dodge 29 spline 4WD NV4500

transmissions. The stock output shaft must be shortened so that when our

spud shaft is assembled it does not push the stock output shaft towards the transmission causing a pre-load on the transmission
bearings. The stock tailhousing is replaced with our new adapter which measures 6.375” long. The transfer case shift controls
will need to be modified to be used with these transmissions. There are two 3/8” holes located on the side of the adapter for the
mechanical shifter linkage. If your vehicle has a 3 speed vacuum-type shifter, these holes are not going to be used. They will need
to be plugged with the hardware provided in the kit along with a small amount of silicone.

P/N 50-0222

Dodge 29 spline 4WD NV4500 replacing FJ40 3 speed (10 spline)

P/N 50-0223

Dodge 29 spline 4WD NV4500 replacing FJ40 4 speed (16 spline)

P/N 50-0224

- Dodge 29 spline 4WD NV4500 replacing FJ40/FJ60 4 speed (19 spline split-case)

This adapter does not have provisions to retain the stock transmission crossmember. When using this NV4500 adapter, a custom crossmember

will need to be fabricated.

This manual is related to the following products:

NV3550 NV4500